¡¡¡¡ ¡¡¡¡
¡¡¡¡ ¡¡¡¡
 
Model Selection Standard of lndustrial Floors¡¡¡¡¡¡¡¡
1.Performance Requirement
Abrasion resistance/what kind of vehicle will be dricen on it£¿
Compression resistance/Howmuch weight will be born on it£¿
shock resistance/What is maximum shocking strength£¿
Acid and alkaline resistance /what is the acid and alkaline concentration£¿
Dissolvent resistane/What kind of dissolvent Will be used and how long will it be touched by the dissolvent£¿
Heat resistance/What are the highest tempera-ture and the lowest temperature£¿
Antistatic/Is it necessary to prevent static charge£¿		 2.Appearance Requirement
color/color selection and area division£¿
brightness/bright of dumb£¿
evenness/Isthere level demand£¿		 3.Safety Requirement
poisonproof/Is there a poisonous floor in the work-shop£¿
Antiskid/Is necessary for you to prevent sliding?
Fireproof /Is there a spark generated£¿
¡¡¡¡ ¡¡¡¡

Operation Conditions and Maintenqance of Ind.Floors¡¡¡¡¡¡¡¡
1.The original cement floor must be even and hard,and there is no leafing.
2.There must be a drainage slope of the whole floor.
3.The new cement floor must be maintained for above four weeks without any walk on it.
4.The moisture content must be below8%
5.Air relatie humidity must be below75%
6.In the temperature below 5¡ã C,special mixing is needed.
7.The old floor coating is not compatible and it should be cleared away completely.
8.After finishing coating,you should maintain enough time to use it.
9.You should sread out a rubber plate to install an eequipment.
10.Rubber tyres must be used on conveying ve-hicles.
11.The oil stains and dirt may be wiped out with detergent.
12.As soon as a part of the floor is filled prop-erly ,it must be patched.

Last one page

¡¡¡¡ ¡¡¡¡